Panasonic DMC-GH2 - Manual (Page 17)

17
VQT3A36
Before Use
There are 2 ways to operate the rear dial, rotating left or right, and deciding by pressing.
Rotating:
Selection of items or setting of values is performed during the various settings.
Pressing:
Operations that are the same as [MENU/SET] button, such as selection of settings
and exiting the menu, are performed during the various settings.
•
Rear dial is described as follows in these operating instructions.
At the time of purchase, [INTELLIGENT AUTO] is assigned to the
[Fn1] button, [FILM MODE] to the
2 (Fn2) button and
[METERING MODE] to the 4 (Fn3) button.
• The functions to be assigned can be selected from the menu below
using [Fn BUTTON SET] in the [CUSTOM] menu.
Note
• Refer to P117 for details about [REC] Mode menu.
• Refer to P129 for details about [CUSTOM] menu.
• When [INTELLIGENT AUTO] is set, pushing the button will switch to Intelligent Auto Mode.
(Pressing the button again or turning off the camera will cancel the setting.)
• When set to [FOCUS AREA SET], it is possible to display the position setting screen of either
AF area or MF Assist.
• When [1 SHOT ] is set, it will record the RAW file and a fine JPEG image simultaneously
once only. It will return to original quality after recording.
• When [1 SHOT Ù] is set, it will record with [METERING MODE] set to [Ù] (spot) once only. It
will return to original Metering Mode after recording.
Rear Dial
e.g.: Rotating left or right e.g.: Pressing the rear dial
Function button
[REC] menu/ Recording functions [CUSTOM] menu
[INTELLIGENT AUTO]/[FILM MODE]/
[FOCUS AREA SET]/[ASPECT RATIO]/[QUALITY]/
[1 SHOT ]/[METERING MODE]/[1 SHOT
Ù]/
[FLASH]/[FLASH ADJUST.]/[ISO LIMIT SET]/
[EX. TELE CONV.]/[BURST RATE]/
[AUTO BRACKET]
[GUIDE LINE]/[SHUTTER AF]/
[PRE AF]/[
REC AREA]
DMC-GH2H&GH2K&GH2PP-VQT3A36_eng.book 17 ページ ２０１０年１０月１９日 火曜日 午前１１時３分