Panasonic DMC-GH2 - Manual (Page 151)

151
VQT3A36
Playback/Editing
Note
• The number of prints can be set from 0 to 999.
• With a printer supporting PictBridge, the date print settings of the printer may take precedence
so check if this is the case.
• It may not be possible to use the print settings with other equipment. In this case, cancel all the
settings, and reset the settings.
• If the file is not based on the DCF standard, the print setting cannot be set.
• The [PRINT SET] feature is disabled for motion pictures and pictures taken with the [QUALITY]
set to [
].
You can set protection for pictures you do not want to be deleted by mistake.
•
For details about the icon display during Burst Picture Group playback, refer to P138.
1 Select [PROTECT] on the [PLAYBACK] Mode menu. (P55)
2 Press 3/4 to select the item and then press [MENU/SET].
• When [SINGLE IN BURST GROUP] or
[MULTI IN BURST GROUP] is selected, press
3/4/2/1 to
select Burst Picture Group, and press [MENU/SET] to proceed to
step
3
.
• When [CANCEL] is selected, see “ Canceling all the [PROTECT]
settings ” .
∫ Canceling all the [PROTECT] settings
1
Select [CANCEL] on the screen shown in step
2
and then press [MENU/SET].
2 Press 3 to select [YES] and then press [MENU/SET].
• If you press [MENU/SET] while canceling protection, the canceling will stop halfway.
Note
• The [PROTECT] feature is only designed to work with this camera.
• Even if you protect pictures on a card, they will be deleted if the card is formatted.
• Even if you do not protect pictures on a card, they cannot be deleted when the card’s
Write-Protect switch is set to [LOCK].
P [PROTECT]
3 Select the picture, and then press
[MENU/SET].
When [MULTI] has been selected
• Repeat these steps for each picture.
• The settings are canceled when
[MENU/SET] is pressed again.
• Press [‚] to return to the menu screen.
[SINGLE] [MULTI]
Press 2/1 to select
the picture.
Press 3/4/2/1 to
select the pictures.
DMC-GH2H&GH2K&GH2PP-VQT3A36_eng.book 151 ページ ２０１０年１０月１９日 火曜日 午前１１時３分