Panasonic DMC-GH2 - Manual (Page 76)

VQT3A36
76
Recording
• In the Quick Menu (P57) while in button operation, if set to [ ] (viewfinder style), after
selecting the Exposure Compensation display using the rear dial or 2/1, pressing the rear dial
or [MENU/SET] will allow you to compensate the exposure with the rear dial or 2/1.
[REC] Mode:
Taking Pictures using Burst Mode
Pictures are taken continuously while the shutter button is pressed.
Select the ones you really like from among the pictures you have taken.
Pictures taken with a burst speed of [SH] will be recorded as a single burst group (P136).
Set the drive mode lever to [ ].
Focus on the subject and take a picture.
A When Burst Mode is set to high speed [H].
• Hold down the shutter button fully to activate the
Burst Mode.
∫ Changing the burst speed
1 Select [BURST RATE] in the [REC] Mode menu. (P55)
2
Press 3/4 to select the burst speed and then press [MENU/SET].
¢1 Number of recordable pictures
¢2 When quality is set to [
], [ ] or [ ], burst speed is 4.5 pictures/second.
¢3 Pictures can be taken until the capacity of the card becomes full. However the burst speed
will become slower halfway. The exact timing of this depends on the aspect ratio, the picture
size, the setting for the quality and the type of card used.
[SH]
(Super high
speed)
[H]
(High speed)
[M]
(Middle speed)
[L]
(Low speed)
Burst speed
(pictures/second)
40 5
¢2
3 2
Live View during Burst
Mode
None None Available Available
¢1
With RAW files — 4 to 7
¢3
Without RAW files Max. 40 Depends on the remaining capacity of the card
¢3
A
DMC-GH2H&GH2K&GH2PP-VQT3A36_eng.book 76 ページ ２０１０年１０月１９日 火曜日 午前１１時３分