Philips VOIP321 - Manual (Page 33)

33
EN
Registering
Register a new handset to base station
Each base can register up to 4 handsets.
1. In idle mode, press .
2. Select ADVANCED SET and press OK.
3. Select REGISTRATION and press OK.
4. Before you enter the PIN, long press on the base for 4 seconds.
Unregister a handset
A handset can un-register another handset registered to the same base. It can also un-register itself.
1. In idle mode, press .
2. Select ADVANCED SET and press OK.
3. Select DELETE HS and press OK.
4. Select the handset you would like to un-register and press OK.
5. Enter the PIN (by default PIN is "0000") and press OK to confirm.
Select the base station
If your handset is registered to more than 1 base, you can select which base the handset will use.
1. In idle mode, press .
2. Select ADVANCED SET and press OK.
3. Select BASE SELECT and press OK.
4. Select the base to use and press OK.
Note : If the base is full, the base would not go into registration mode. See the section “Unregister a
handset”, page 33 to unregister a currently registered handset.
Note : The range of this handset is 250 m outdoor and 50 m indoor. An out of range warning will be
emitted and the range icon will be flashing on the display if you move too far away from the base unit
during a call. You will need to move closer to the base unit or your call will be disconnected.
Note : Bases your handset is registered to which is not Philips VOIP 321 base will be labelled as GAP
BASE; your Philips VOIP 321 base will be labelled as BASE in Base Select.
Other features