PYLE Audio PLCD20CH - Manual (Page 21)

21
Control and Function Keys
1. +12V TO IGNITION
Connect the red power wire (with in-line fuse holder) to a point in your vehicle’s fuse
block that has power only when you turn the vehicle’s key to either the accessory
(ACC) or START position.
2. ANTENNA
If your system does not have an RCA input jack, use the FM Modulator to covert
CD Changer’s sound to FM signal. You can then hear it by tuning your vehicle
system to FM frequency.
• Disconnect your vehicle’s antenna from your vehicle’s sound system, then connect
the antenna to the FM Modulator’s large black antenna connector.
• Connect the FM Modulator’s antenna plug to your sound system’s antenna jack.
3. GROUND (–) / BACK UP
• Connect the black ground wire to a chassis ground, such as a metal screw
attached to a metal part of the vehicle’s frame. Be sure that the screw is not
insulated from the chassis by a plastic part.
• Connect the pink memory back up wire (with in-line fuse holder) to your vehicle
battery’s positive (+) terminal or to a fuse that provides a continuous source of
12 volts.
5A
PINK
BLACK
BLACK
BLACK
0.5A
RED
3 2
7 6 5
1 4