Panasonic 744T - Manual (Page 46)

744T User Guide and Technical Information
44
firmware v. 1.04 Features and specifications are subject to change. Visit www.sounddevices.com for the latest documentation.
Setup Menu
The setup menu controls a wide range of parameters for the 744T, including all audio routing,
recording settings, and time code options. The setup menu is a single, fl at architecture with no sub-
menus, easing navigation. Each setup controls a specifi c parameter with several selections. The chart
below shows the setup number, a description of the control, and the menu options available.
# Setup Name Setup Description Setup Parameters
1 Quick Setup Allows the user to quickly apply default
menu setups and save/retrieve user
setups to disk or CF. • Load Factory Settings
- restores the factory default settings
• Load Film Settings
- applies typical setups for film production
• Load Music Settings
- applies typical setups for music recording
• Load User from INHDD
- applies settings saved by user to hard disk
• Load User from CF
- applies settings saved by user to CF
• Save User to INHDD
- saves present state to file on hard drive
• Save User to CF
- saves present state to file on CF
2 Rec: Sample Rate Sets the audio sampling frequency of the
744T • 32 kHz
• 44.1 kHz
• 48 kHz
• 48.048 kHz
• 88.2 kHz • 96 kHz
• 96.096 kHz
• 174.4 kHz
• 192 kHz
3 Rec: Bit Depth Sets the bit depth of the 744T recordings. • 16 bit,
• 24 bit
4 File: Format Selects the file format type recorded to
the selected medium. WAV and BWF files
are identical, the only difference is the
file extension. • .WAV poly
• .WAV mono
• .BWF poly
• .BWF mono
• .MP3 – 64 kb/s • 96 kb/s • 128 kb/s • 160 kb/s
• 192 kb/s • 256 kb/s • 320 kb/s
5 Rec: Media Select Selects the media used for recording. All
media are selectable even if not present. • IN HDD Only
• CF Only
• IN HDD and CF
6 Rec: Take Counter Reset-able numeric counter that incre-
ments every time record is pushed. Used
to create unique file names. <number>
7 Rec: Scene Number Numeric scene number used for file
naming. <number>
8 Rec: Pre-Roll Time Selects the amount of pre-roll time the
744T will add to the beginning of each
file. 0–10 sec. @ 48 kHz
0–5 sec. @ 88.2–96.096 kHz
0–3.5 sec. @ 192 kHz
9 Rec: Dither Selects whether to dither is added to 24
bit digital signals while recording 16 bit
files. • Off
• On (16 bit only)
10 Rec: Timer Start Sets a specific start time/date for unat-
tended recording. Unit must be powered. <enter time, date>