Philips CCA092AT - Manual (Page 9)

Turning On the TV/VCR 9
Before you turn on the TV/VCR, make sure batteries are in the
remote control and the TV/VCR is hooked up correctly.
The instructions on this page work only when you turn on the
TV/VCR for the first time.
1
Press the POWER button. The TV/VCR will come on and the
screen shown below will appear.
2
Press the PLAY/ K button or the STOP/L button to select
English or Spanish on-screen displays and menus.
3
Press the MENU button. The screen shown below will appear.
4
Press the F.FWD/B button to begin automatic channel
setup. The TV/VCR will memorize all available channels. When
channels are set, CHANNELS ARE SET will appear on the screen
briefly. Then the TV/VCR will go to the lowest channel pro-
grammed.
(If you try to set up channels when there is no antenna or cable
connected to the TV/VCR, programming will appear to take place,
but eventually a NO TV SIGNALS ... message will appear on the
screen. Connect an antenna or cable to the ANT(enna) jack on
the TV/VCR, then press the F.FWD/B button again. You may
need to follow the steps on page 11 instead.)
CONNECT ANTENNA OR CABLE
TO TVCR
THEN PRESS B
TO END PRESS EXIT
SELECT LANGUAGE
> ENGLISH ON
ESPAÑOL
SELECT KL OR
PRESS MENU TO CONTINUE
5
Use the CH(annel) m/n button or the Number buttons
on the remote control to select a TV/VCR channel. Use
the VOL(ume) m/n button to adjust the sound.
• If you do not see any on-screen dis-
plays when you turn on the TV/VCR,
check your hookups, then try again.
If you still do not see any on-screen
displays, follow the steps on pages
10-11 to select a language and set
up channels.
• To skip step 2, press the MENU
button. All on-screen displays will be
in English. To skip step 4, press the
STATUS/EXIT button. Channels will
not be set up, and CHANNELS
NOT SET will appear on the screen
briefly.
• You cannot set up channels if you
are using a Cable Box.
• Line Input mode will always be
stored in the TV/VCR’s memory as
channel 00. When you select chan-
nel 00, A/V IN will appear on the
screen briefly. Press the CH(annel)
m
/n button or the Number but-
tons to select another channel.
Helpful Hints
1
2
3
4
5
VOL.
CH.
3 2 1
6 5 4
9 8 7
0
POWER
STATUS/EXIT
TRACKING REC/OTR
SPEED MEMORY
ALT. CH
PAUSE/STILL
MUTE
F.FWD REW
PLAY
STOP
SLEEP
MENU CLEAR