Polycom KIRK 14117800 - Manual (Page 100)

100 Configuring KIRK Wireless Server 600v3
14117800, Ed.2.6
• If CISCO network: It is recommended to change the TOS priority - RTP Data to
0xb8.
3
In the TOS priority - Signalling field, type a TOS priority.
Depending on the network, it may be necessary to change the TOS priority.
• Most networks: The default TOS priority is: 0x10
• If CISCO network: It is recommended to change the TOS priority - RTP Data to
0x68.
For information about the TOS priorities used in your network, contact you system
administrator.
4 Click Reset (under Administration menu) to save your configuration.
The Master (Primary) KWS600v3 is now configured.
7.6.2 Configuring Sync Master
This section describes how to configure a Sync Master KWS600v3 in a multi-cell solution.
KWS600v3 primary and secondaries use the existing DECT air interface to synchronize to
each other on. One KWS600v3 is configured as a Sync (synchronization) Master in the
system. It is not necessary to configure what KWS600v3 the Sync Master should
synchronize to.
This section includes information about:
• “Assigning a Specific IP Address (Sync Master)” on page 100
• “Configuring LDAP Replicator (Sync Master)” on page 102
• “Configuring DECT Master (Sync Master)” on page 103
• “Configuring DECT Radio (Sync Master)” on page 103
For information on accessing the web based Administration Page, refer to “Accessing the
Web Based Administration Page” on page 79 .
7.6.2.1 Assigning a Specific IP Address
(Sync Master)
To assign a specific IP address to the KWS600v3, it is necessary to disable the DCHP
mode and then assign a specific IP address to the KWS600v3. The new IP address and
network address will be provided by the system administrator.