Pioneer Video Card PDA-5002 - Manual (Page 4)

4
En
Part Names and Functions
English
Part Names and Functions
Plasma Display Section
The plasma display is provided with 2 video input
connectors, 1 video output connector, audio input/output
jacks and speaker terminals.
There are also CONTROL IN/OUT jacks for connection of
PIONEER components with the
Î mark.
When this video card is installed on a plasma display, an
additional three sets of video input connectors are
provided (total five), together with one additional video
output connector (total two). See the pages noted in
parentheses ( ) or the plasma display’s Operating
Instructions for details regarding connections to the
various jacks and connectors.
1
SPEAKER (R) terminal
For connection of an external right speaker.
Connect a speaker whose impedance is 8 -16
Ω.
2
CONTROL IN/OUT (monaural mini jacks)
For connection of PIONEER components that bear the
Î mark. Making CONTROL connection enables
control of the plasma display as a component in a
system.
3
COMBINATION IN/OUT
DO NOT MAKE ANY CONNECTIONS TO THESE
TERMINALS.
These terminals are used in the factory setup.
Connection Panel
4
RS-232C
DO NOT MAKE ANY CONNECTIONS TO THIS
TERMINAL.
This terminal is used in the factory setup.
5
INPUT1 (mini D-sub 15 pin)
For connection of components that have RGB or
component output jacks such as a personal
computer, DVD player, or external RGB decoder.
Make sure that the connection made corresponds to
the format of the signal output from the connected
component (pages 7 to 10).
6
OUTPUT (INPUT1) (mini D-sub 15 pin)
Use the OUTPUT (INPUT1) connector to output the
video signal to an external monitor or other
component.
Note: The video signal will not be output from the
OUTPUT (INPUT1) connector when the main power of
this display is off or in standby mode.
(page 10)
7
INPUT2 (BNC jacks)
For connection of components that have RGB or
component output jacks such as a personal computer,
DVD player, or external RGB decoder. Make sure that
the connection made corresponds to the format of the
signal output from the connected component (pages 7
to 9).
~ = -
L
AC INLET
OFF ON
SPEAKER
8 Ω ~16Ω
+ —
@ ! # $ % ^
AUDIO INPUT5 INPUT3 S-VIDEO
R L DIGITAL RGB
AUDIO INPUT4 VIDEO OUTPUT
R L
1 2 3 4 5 6 7 89 0
IN OUT
CONTROL COMBINATION
IN OUT
RS-232C
ANALOG RGB (ANALOG RGB)
INPUT1
OUTPUT G B R HD VD
(ON SYNC) (H/V SYNC)
Ô 75 2.2 Ω k Ω
INPUT
(INPUT1/2)
OUTPUT R
SPEAKER
8 Ω ~16Ω
+ —
INPUT2 AUDIO