Panasonic PT-LB51NTE - Manual (Page 20)

E
NGLISH - 20
B
asi
c Op
eration
Switching the projector on/off
J Connecting
1. Make sure the shape of the mains plug and the AC IN connector on the back of
the projector match, then push the plug all the way in.
2. Connect the Mains lead to a mains socket.
J Disconnecting
1. Check that the POWER indicator of the POWER button is lit red, and then unplug the Mains lead from the
mains socket.
2. Hold the plug and unplug the Mains lead from the AC IN connector on the back of the projector.
J Direct power off function
You can disconnect the Mains lead during projection or immediately after use and move the projector. The
cooling fan will operate by the internal power supply to cool down the lamp.
When this function is used, it may take more time for the lamp to turn back on again compared to when the lamp cools
down with the Mains lead connected.
Do not put the projector in a bag while the POWER button on the projector is illuminated.
J Direct power on function
If you activate the DIRECT POWER ON, you can start the projection only with connecting the Mains lead. See
“DIRECT POWER ON” on page 37.
Mains lead
NOTE:
• Do not use other than a provided Mains lead.
• Ensure all the input devices are connected and turned off before connecting the Mains lead.
• Do not force the connector as this may damage the projector and/or the Mains lead.
• Dirt or dust build-up around plugs may cause fire or electrical hazards.
• Switch off the power to the projector when not in use.