Promise Technology UltraTrak100 TX8 User Manual
Page 54
UltraTrak100 TX4 and UltraTrak100 TX8
User Manual
48
Q.
Why can’t I see the drives on the UltraTrak100 under FDISK?
A.
If you have not created an array, the physical drive(s) attached to the
UltraTrak100 card will not be recognized by the operating system. The
UltraTrak100 controller is dedicated to RAID array management and does
not provide any means of addressing individual hard drives through the int
13h interface used by FDISK. In order to access drives on the UltraTrak100
from MSDOS at all, you must first create a RAID array.
Q.
Why can’t I see the array I just created in the Windows NT/2000 Disk
Administrator?
A.
Since Windows NT/2000 does not yet support any method of dynamically
adding and/or removing logical devices to/from the system, you must restart
Windows. The next boot will show the new array under Disk Administrator.