Pride Mobility Maxima Mobility Scooter - Manual (Page 30)

30 www.pridemobility.com Maxima
Figure 13. Seat Height Adjustment
SEATBACK ADJUSTMENT
The seatback may be positioned to four different
angles: 90°, 100°, 102° and 105°. See figure 12.
To adjust the seatback angle:
1. Loosen and remove the adjustment screws
from the seatback hinge on both sides of the
seat.
2. Reposition the seatback to the desired angle.
3. Align the adjustment holes from the upper
and lower hinge, so the adjustment screw can
easily pass through.
4. Reinsert both adjustment screws and tighten.
90° ADJUSTMENT HOLE
100° ADJUSTMENT HOLE
102° ADJUSTMENT HOLE
105° ADJUSTMENT HOLE
Figure 12. Seatback Hinge
ADJUSTMENT SCREW
UPPER HINGE
LOWER HINGE
V I I I . C O M F O R T A D J U S T M E N T S
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to different heights.
See figure 13.
1. Remove the seat and shroud from your
scooter. See IX. “Disassembly and
Assembly.”
2. Loosen the nut and remove it from the bolt,
and remove the bolt and washers from the
lower seat post.
3. Raise or lower the upper seat post to the
desired seat height.
4. While holding the upper seat post at that
height, match up the holes in the upper seat
post with those of the lower seat post.
5. Fully insert the bolt, reinstall the washers,
and tighten the nut.
Note: Ensure both washers have been reinstalled
before fully tightening the nut.
6. Reinstall the rear shroud and the seat.
LOWER SEAT POST
UPPER SEAT POST
NUT
WASHER
BOLT
WASHER