Philips AZ5836 - Manual (Page 24)

24
English
IMPORTANT!
– Before playing a tape, check and
tighten slack tape with a pencil. Slack
tape may get jammed or may burst in
the mechanism.
– Store tapes at room temperature and
do not put them too close to a magnetic
field (for example, a transformer, TV set
or speaker).
– In disc mode or tuner mode, tape
playback is not available but record
function is available.
Tape playback
Press STANDBY-ON B to switch on the set.
1
Press
0 on the set to open the tape deck door.
2
Insert a recorded tape and close the tape door.
● Load the tape with the open side up and the full
spool to the right.
3
Press SOURCE repeatedly or TAPE on the
remote control to select TAPE source.
4
Press 2 on the set to start playback.
Interruptting playback
● Press ; to interrupt playback.
Stopping playback
●
Press
7 / 0 to stop playback.
Tape Operation/Recording
Rewinding or forwarding fast when
playback is stopped
1
Press 1 or ¡ on the top of the system.
2
Press 7 / 0 when you reach the desired
passage.
General information on
recording
● Recording is permissible insofar as copyright or
other rights of third parties are not infringed.
●
For recording, only use tape of IEC type I(normal
tape).
●
The recording level is set automatically,
regardless of the position of the Volume, Vocal,
Key control and so forth.
●
The type is secured at both ends with leader
tape. At the beginning and end of the tape,
nothing will be recorded for seven seconds.
●
To prevent accidental recording, break out the
tab on the left shoulder of the tape side you
want to protect.
● In Disc, TUNER or USB mode, the record key ●
can’t be pressed if there is no recordable tape in
tape deck.
AZ5836_58_P01-31_Eng 2008.3.13, 10:29 24