Pioneer SUPER TUNER III D FH-P8000BT - Manual (Page 49)

Note
You can match the clock to a time signal by
pressing
MULTI-CONTROL.
! If 00 to 29, the minutes are rounded down.
(e.g., 10:18 becomes 10:00.)
! If 30 to 59, the minutes are rounded up. (e.g.,
10:36 becomes 11:00.)
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source on page 53.
1 Display the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Use MULTI-CONTROL to select AUX1/
AUX2.
3 Press MULTI-CONTROL to turn AUX1/
AUX2 on.
# To turn AUX off, press MULTI-CONTROL
again.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car
’s headlights are turned on. You
can turn the dimmer on or off.
1 Display the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Use MULTI-CONTROL to select DIMMER.
3 Press MULTI-CONTROL to turn dimmer
on.
# To turn dimmer off, press MULTI-CONTROL
again.
Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
REAR SP :FULL) or subwoofer
( REAR SP :S/W) connection. If you switch the
rear output setting to REAR SP :S/W, you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
REAR SP :FULL).
1 Display the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Use MULTI-CONTROL to select
S/W CONTROL.
3 Press MULTI-CONTROL to switch the
rear output setting.
Pressing
MULTI-CONTROL will switch be-
tween REAR SP :FULL (full-range speaker) and
REAR SP :S/W (subwoofer) and that status will
be displayed.
# When no subwoofer is connected to the rear
output, select
REAR SP :FULL (full-range speak-
er).
# When a subwoofer is connected to the rear
output, select
REAR SP :S/W (subwoofer).
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
46).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Initial Settings
En
49
Section
04
Initial
Settings