Read me first, Models for u.s.a – Panasonic CF-30 User Manual

Page 3

Advertising
background image

3

Getting Started

Read Me First

Models for U.S.A.

Federal Communications Commission Radio Fre-

quency Interference Statement
Note: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential instal-

lation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interfer-

ence will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one

or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and

receiver.

Connect the equipment into an outlet on a circuit dif-

ferent from that to which the receiver is connected.

Consult the Panasonic Service Center or an experi-

enced radio/TV technician for help.

Warning
To assure continued compliance, use only shielded inter-

face cables when connecting to a computer or peripheral.

Also, any changes or modifi cations not expressly ap-

proved by the party responsible for compliance could void

the user’s authority to operate this equipment.

FCC RF Exposure Warning:

This equipment is provided with PC Card slot that could

be used with wireless transmitters, which will be specifi -

cally recommended when they become available.

Other third-party wireless transmitters have not been

RF exposure evaluated for use with this computer and

may not comply with FCC RF exposure requirements.

<Only for model with wireless LAN/Bluetooth>

This equipment complies with FCC radiation exposure

limits set forth for an uncontrolled environment.

This equipment has been approved for mobile operation,

and unless otherwise advised in separate supplemental

instructions for individual wireless transmitter(s), requires

minimum 20 cm spacing be provided between antenna(s)

and all person’s body (excluding extremities of hands,

wrist and feet) during wireless modes of operation.

This equipment may use multiple installed transmitters,

which may be capable of simultaneous transmission.

This equipment is provided with external antenna

connector(s) for connection to optional Car Mounter or

Port Replicator for mobile external mounted antenna(s).

External antenna(s) must be professionally installed and

cannot exceed recommended maximum antenna gain as

described in individual provided supplement instructions

for wireless transmitters. Also, user must maintain mini-

mum 20 cm spacing between external antenna(s) and all

person’s body (excluding extremities of hands, wrist and

feet) during wireless modes of operation.

25-M-3-1

<Only for model with wireless LAN>

This product is restricted to indoor use due to its operation

in the 5.15 to 5.25 GHz frequency range. FCC requires this

product to be used indoors for the frequency range 5.15 to

5.25 GHz to reduce the potential for harmful interference

to co-channel Mobile Satellite systems. High power radars

are allocated as primary users of the 5.25 to 5.35 GHz and

5.65 to 5.85 GHz bands. These radar stations can cause

interference with and/or damage this product.

25-M-W-1

This device complies with Part 15 of the FCC Rules. Op-

eration is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received,

including interference that may cause undesired op-

eration.

Responsible Party: Panasonic Corporation of North America
One

Panasonic

Way

Secaucus, NJ 07094

Tel No:1-800-LAPTOP5 (1-800-527-8675)

6-M-1

FCC Regulation Notice for modem

This equipment contains a FCC approved modem.

1. This equipment complies with CFR47 Part 68 rules.

On the computer is a label that contains, among other

information, the FCC registration number and ringer

equivalence number (REN) for this equipment. If re-

quired, this information must be provided to the tele-

phone company.

2. An FCC compliant telephone cord and modular plug

is provided with this equipment. This equipment is

designed to be connected to the telephone network

or premises wiring using a compatible modular jack

which is Part 68 compliant. See Installation Instruc-

tions for details.

3. The REN is used to determine the quantity of devices

which may be connected to the telephone line. Ex-

cessive RENs on the telephone line may result in the

devices not ringing in response to an incoming call. In

most, but not all area, the sum of RENs should not ex-

ceed fi ve (5.0). To be certain of the number of devices

that may be connected to a line, as determined by the

total RENs, contact the local telephone company.

4. If your telephone equipment cause harm to the tele-

phone network, the telephone company will notify you

in advice that temporary discontinuance of service

may be required. But if advice notice isn’t practical, the

telephone company will notify the customer as soon

as possible. Also, you will be advised of your right to

fi le a complaint with the FCC if you believe it is neces-

sary.

5. The telephone company may take changes in its facili-

ties, equipment, operations or procedures that could

affect the operation of the equipment. If this happens

the telephone company will provide advance notice

in order for you to make necessary modifi cations to

maintain uninterrupted service.

6. If trouble is experienced with this equipment, for repair

or warranty information, please contact Panasonic

Corporation of North America at DIAL TOLL FREE

1-800-LAPTOP5 (1-800-527-8675). If the equipment is

causing harm to the telephone network, the telephone

company may request that you disconnect the equip-

ment until the problem is resolved.

7. There are no user serviceable parts contained in this

equipment.

8. This equipment may not be used on coin service pro-

vided by the telephone company. Connection to party

lines is subject to state tariffs.

CF-30CTQZZBM.indb 3

CF-30CTQZZBM.indb 3

12/4/2007 10:01:20 AM

12/4/2007 10:01:20 AM

Advertising