Connecting the shdsl rj21 cable, Procedure – Paradyne 24-Port SHDSL Mini DSLAM SMD2000-24T User Manual
Page 11
11
7. Verify the connection. Turn your power source ON. The PWR (power) LED on
your SMD2000-24T faceplate will illuminate solid green to indicate that the chassis
is receiving power.
Connecting the SHDSL RJ21 Cable
Procedure
To connect the SHDSL cable to the SMD2000-24T RJ21 connector:
1. Configure the SHDSL lines.
No configuration is necessary for the SMD2000-24T to operate at default settings.
However, if you wish to run subscriber lines at settings other than the
SMD2000-24T defaults, configure the subscriber lines prior to connection.
Parameter settings may be changed using the Command Line Interface (CLI),
Simple Network Management Protocol (SNMP), or the web-based management
system.
on page 15 lists the device defaults.
on page 3 lists the user interface manuals.
2. Detach the hook-and-loop fastener strap from the RJ21 socket on the front of the
chassis and pull it upward, leaving it looped under the connector frame at the top.