Panasonic MC-CG663 - Manual (Page 6)

4
A) Turbine nozzle (MC-CG663, MC-CG663K only)
B) Floor nozzle (MC-CG661, MC-CG661K only)
C) Connection pipe
D) Hose
E) Suction regulator
F) Curved wand
G) Telescopic wand (MC-CG663, MC-CG663K)
(MC-CG661, MC-CG661K)
H) Hose inlet
I) Dust indicator
J) Dust cover
K) ON/OFF Switch pedal
L) Cord rewind pedal
M) Crevice nozzle
N) Dusting brush
O) Parquet floor nozzle (MC-CG661, MC-CG661K only)
P) Exhaust cover
Q) Plug
R) Variable power control button
B-1 Insert connection pipe into hose inlet until it locks.
When removing hose assembly, pull out connection
pipe with pushing down two connection buttons.
NOTE: Do not bend, pull, and step on the hose or put
anything heavy on it.
B-2 Insert the hose unit into the upper end of the connected
telescopic wand, and the floor nozzle to the other end.
(Only MC-CG661, MC-CG661K)
B-3 Insert the hose unit into the upper end of the telescopic
wand.
Twist the telescopic wand so that the round hole will fit
into the tab on the hose unit. (When removing the
hose, push the tab down whilst pulling on the
telescopic wand)
Attach the Turbine Nozzle to the other end (Only MC-
CG663, MC-CG663K)(Removal as per reverse
procedure)
B-4 Keep hold of the wand grip and pull out the wand to the
required length.
C-1 Pull out the mains lead and put the plug into the
wall socket.
C-2 Gently press at the center of the switch pedal to
turn ON the vacuum cleaner.
Press the pedal again to turn it OFF.
C-3 Power control
To increase or decrease the power, turn the variable
power control.
C-4 Switching between carpet and flooring
Flooring: Press lever A
Carpet: Press lever B
*Switching 3 positions for MC-CG663, MC-CG663K.
Flooring (PARQUET): Set position A
Carpet (short): Set position B
Carpet (long or hard to push): Set position C
C-5 The curved wand of the hose is attached with a manual
suction regulator, which allows you to briefly reduce the
suction level.
C-6 After you finish vacuuming, remove the plug from
the wall socket and press the cord rewind pedal.
When rewinding the mains lead, press at center of
rewind pedal by holding the plug so that it does not
become damaged.
C-7 Storage position
Insert the wand holder straight into the wand
supporter.
C-8 Park system
For short breaks during vacuuming, slide the hook
attached to the nozzle pipe into the slot on the rear
side of the cleaner.
NOTE: When you use park position, we suggest the
appliance is switched off.
A - IDENTIFICATION OF MAIN PARTS
B - HOW TO ASSEMBLE YOUR CLEANER
C - HOW TO OPERATE YOUR CLEANER