Panasonic AMX-25 - Manual (Page 6)

6
7. Set BASS on the back of each
speaker to ON for a deeper, richer
bass sound.
Be sure to turn off the speakers when
you are not using them.
If you hear distorted sound, check
these things:
• Adjust TUNING on the speakers
• Change the position of the trans-
mitter
• Rotate FREQ. ADJUST on the
transmitter and then adjust TUN-
ING until the interference goes
away
• Adjust LEVEL on the transmitter
so the indicator at the front of the
transmitter occasionally flickers
ADJUSTING THE
FREQUENCY
If you receive interference from other
devices, you might be able to reduce
it by adjusting the speaker’s operating
frequency. Simply rotate
FREQ. AD-
JUST on the transmitter, then rotate
TUNING on each speaker until the au-
dio is free from interference.
IF YOU HAVE
A PROBLEM
If you cannot get sound once you
have connected the system, check
these things:
• Make sure you rotate each
speaker’s POWER/VOL knob
clockwise until it clicks so the
speakers are turned on
• Be sure the AC adapters are
plugged in and have power
• Be sure the audio source is
turned on and tuned to an active
frequency
• If you have connected to jacks
that are controlled by the audio
source’s volume control, be sure
the source’s volume control is
turned up
• Adjust the speaker’s volume con-
trol
• Adjust TUNING on the speakers
• Change the position of the trans-
mitter
If you still have a problem with the
speaker system, see your local Ra-
dioShack store for assistance.
40-1372.fm Page 6 Tuesday, August 10, 1999 3:25 PM