Patton electronic SmartNode 4830 Series - Manual (Page 36)

Installing the VoIP IAD 36
SmartNode 4830 Getting Started Guide 3 • Hardware installation
Figure 15. Connecting a SmartNode 4830 Series device to a hub
Installing the serial WAN cable
The SmartNode 4830 Series is available with the following serial interfaces):
• DSL (RJ11)—See section “Installing the DSL interface cable” on page 37 for details on installing the inter-
face cable
• V.35 (DB-25)—See section “Installing the V.35 interface cable” on page 37 for details on installing the
interface cable
• X.21 (DB-15)—See section “Installing the X.21 interface cable” on page 38 for details on installing the
interface cable
• T1/E1 (RJ48C connectors)—See section “Installing the T1/E1 twisted pair cables” on page 39 for details
on installing the twisted pair cable
• E1 (Dual coaxial connectors)—See section “Installing the E1 dual coaxial cables” on page 40 for details on
installing the coaxial cables
Hub
Straight-through cable
SmartNode: RJ-45, male
Tx+
Tx-
Rx+
Rx- 1
2
3
6
Hub/switch: RJ-45, male
1 Rx+
2 Rx-
3 Tx+
6 Tx-