Panasonic CF-Y4 - Manual (Page 53)

53
Troubleshooting
E The message "[Recovery] is complete" will be displayed. Remove the Prod-
uct Recovery DVD-ROM, and press any key to shut down the computer.
4
Return the Setup Utility settings to their default values.
Return the Setup Utility to its settings at the time of purchase to ensure
proper setup of Windows.
A
Turn on the computer, and press the F2 key while [Panasonic] boot
screen is displayed.
The Setup Utility will start up.
If the password has been set, enter the Supervisor Password, and press
the Enter key.
B Press the F9 key.
At the confirmation message, select [Yes] and press the Enter key.
C Press the F10 key.
At the confirmation message, select [Yes] and press the Enter key.
The Setup Utility will close, and the computer will restart.
5
Setup Windows. (Î page 18)
6
Run the Setup Utility and change the settings where necessary.
(The Setup Utility settings will return to their default values. Even the security settings
with the exception of the password(s), date and time will return to their default values.)
7
If you can connect to the Internet, perform Windows Update.
(Î “To Update this Computer to its Latest Version” in onscreen Reference Manual)
Changing the drive letter
You can change the drive letter for the DVD-ROM & CD-R/RW drive or hard disk drive
by the following steps.
z
The C drive cannot be changed.
z The drive letter for A Drive, B Drive and C Drive cannot be changed. You also can-
not use a drive letter that is currently being used by another device, or a drive letter
that has already been allocated to a network drive.
‹ Changing the hard disk drive letter
A Click [start] - [Control Panel] - [Performance and Maintenance] - [Admin-
istrative Tools], and double-click [Computer Management].
B Click [Disk Management] in [Storage].
C Right-click a partition of the hard disk, and click [Change Drive Letter and Paths].
D Click [Change].
E Click [Assign the following drive letter], select a drive letter, then click [OK].
F Click [Yes] when the confirmation message is displayed.
‹ Changing the internal DVD-ROM & CD-R/RW drive letter
(Î page 20)