Pentair 720 - Manual (Page 15)

11
Prowler ™ 720 and 730 Installation and User’s Guide
Cable Care
The cable may become twisted after a period of use. To correct this condition,
simply lock the moveable handle on the top of the cleaner in the
opposite diagonal direction. The pool cleaner will now travel in the opposite
direction while cleaning your pool and the cable will uncoil. Check the cable
periodically for external damage. If the problem persists, use the E-Z Swivel
device.
Place the Robot on the ground and unplug the cable from the transformer.
With one hand holding the E-Z Swivel, walk away from the Robot, pulling
the cable to its full length. The core will rotate inside the cover which will
untangle the cable, see Figure 19.
Important Maintenance Tips
1. Shut off and unplug the power supply every time you remove the cleaner
from the water.
2. Clean the filter bag after every cycle.
3. Reverse the handle after every cleaning cycle to avoid tangling the cable.
4. Periodically straighten out the floating cable.
5. Replace worn brushes to ensure maximum cleaning performance.
6. Make sure that your pool cleaner positions itself properly on the wall. The
machine handle must rest parallel to the water line upon reaching the
surface of the water.
7. Save your cleaner's packaging for off-season storage or for shipping the
unit to your dealer if service is required.
8. Store the unit and accessories on the caddy.
9. Leave your pool cleaner in the water for 15 to 20 minutes after every cleaning cycle.
10. Do not leave your cleaner in direct sunlight when not in use.
11. Never leave the power supply in direct sunlight and avoid leaving it in the rain.
12. Occasionally, you should rinse your cleaner in clean, fresh water. This will lengthen the service life of the drive
belts, drive tracks and scrubbing brushes.
In-Season Storage
Do not leave your Prowler™ cleaner in the pool when not in use. Doing so, will reduce the life of your Filter Bag
and the Prowler™ cleaner. After removing the Prowler™ cleaner from the pool, you should clean and re-install
the Filter Bag. Then, rest the Prowler™ cleaner on its side in a dry shaded area along with its Power Supply and
properly coiled Floating Cable.
Off-Season Storage
When the Pool Season is over, you should thoroughly clean the Filter Bag. Make sure that there is no water in the
Prowler™ cleaner. Completely untangle and then properly coil the Floating Cable. Your Prowler™ cleaner and
Power Supply should be stored in a dry, protected area away from freezing temperatures.
E-Z SWIVEL - Location
Handle Cover
Core
Cable
Assy.
patent pending
Figure 19.