Peavey Penta Tube Amplifier - Manual (Page 12)

12
™
Tube Amplifier
SPECIFICATIONS
Tube Complement:
Four matched EL34 tubes
Four 12AX7/ECC83 tubes
Rated Power and Load:
140 W (rms) into 16, 8 & 4 ohm
External jacks are paralleled - 4 ohms minimum
The following specs are measured @ 1 kHz with the controls preset as follows:
Bass, Treble & Mid EQ @ 5
Master Volume @ 1O
(Nominal levels are with Pre Gain @ 5. Minimum levels are with Pre Gain @ 10.)
Preamp Input Section (1 st channel):
Nominal Input Level: 0 dBV, 1V RMS
Minimum Input Level: -20 dBV, 100 mV RMS
Maximum Input Level: 6 dBV, 2V RMS
System Signal-to-Noise:
(1st channel - 20 Hz to 20 kHz unweighted)
(Pre Gain set halfway)
Greater than 80 dB below rated power
Equalization:
Custom Bass, Mid, & Treble passive type EQ for each mode
Remote Footswitch (included):
Heavy duty 1-button footswitch
Power consumption:
Domestic: 300 watts, 60 Hz, 120 VAC
Export: 300 watts, 50/60 Hz, 220-230/240 VAC
Dimensions:
17.875" H x 21.375" W x 10.25" D
(45.40 cm x 54.29 cm x 26.03 cm)
Weight:
57.8 lbs. (26.24 kg) with power supply
Specifications subject to change without notice.