Pride Mobility Jazzy 1107 INFINFB2041 User Manual

Page 2

Advertising
background image

INFINFB2041/Rev A/11-29-06

www.pridemobility.com

2

B

ASIC

T

ROUBLESHOOTING

I

NSTRUCTIONS

: J

AZZY

1107

What if my Jazzy 1107 begins pulling to one side?
! Determine if the joystick is being deflected straight or at a slight angle. Even a small amount of deflection

right or left will cause the chair to veer over a long distance.

! Determine if both manual freewheel levers are in the drive position. If only one manual freewheel lever is

in the drive position, the other motor will not operate and the Jazzy 1107 will veer severely.

! Determine if both tires are inflated to the proper psi if the power chair is equipped with pneumatic tires.

Pneumatic tires should be inflated to 35 psi (2.4 bar). If one tire is inflated more than the other, the power chair
will pull to the side that is underinflated.

! Determine if the caster wheels are pivoting freely. If either caster wheel is not pivoting freely, the unit will

veer to the side.

What if the Jazzy 1107 powers up, but will not move?
! Determine if both manual freewheel levers are in the freewheel position. If the power chair is in freewheel

mode, then the electronics will function but the motors will not spin the wheels.

! Determine if the battery condition meter LEDs are flashing a fault code. The Jazzy 1107 comes equipped

with either a VSI or FLIGHT controller. Each controller will flash a code via the battery condition meter LEDs
if a system fault is detected.

VSI DIAGNOSTIC FLASH CODES

# OF LEDS

CODE

CAUSE

POSSIBLE SOLUTION

One red LED

1

Low battery voltage

Charge batteries

Two red LEDs

2

Left motor open

Make sure left motor is plugged into controller.

Three red LEDs

3

Left motor wiring fault

Contact your authorized Pride Provider.

Three red LEDs

4

Right motor open

Make sure right motor is plugged into controller.

One yellow LED
Three red LEDs

5

Right motor wiring fault

Contact your authorized Pride Provider.

Two yellow LEDs
Three red LEDs

6

Inhibit active

Contact your authorized Pride Provider.

Three yellow LEDs
Three red LEDs

7

Joystick error

Contact your authorized Pride Provider.

Four yellow LEDs
Three red LEDs

8

Controller error

Contact your authorized Pride Provider.

Four yellow LEDs
One green LED
Three red LEDs

9

Brake fault

Make sure both motors are plugged into controller.

Four yellow LEDs
Two green LEDs
Three red LEDs

10

High battery voltage

Contact your authorized Pride Provider.

Four yellow LEDs
Three green LEDs

Advertising