Pitney Bowes ADDRESSRIGHT DA400 - Manual (Page 21)

2-4
Setup
2. Installing the Wire Frame Assembly
A. Turn the Clamp Knob to
loosen the Feed Ramp.
Slide the Ramp to the
top of the Wire Frame
Assembly and retighten
the Clamp Knob to
secure it.
B. Hold the Wire Frame
Assembly nearly vertical with the Feed Ramp on the
upper end and the Deflector Plate on the lower end.
C. Insert the Deflector
Plate and Slide into the
channel in the Upper
Floor Assembly. Slide the
Wire Frame Assembly
to the center of the floor.
When properly installed,
the slide is contained
in the channel by the
lips on both sides of the
channel.
D. Locate the Clamp Knob
on the back of the
printer’s Upper Floor
Assembly. Turn to loosen
the Clamp Knob and
move it over to align it
to the center of the Wire
Frame Assembly.
Assembling
the Printer
(continued)
SV61186ABook.indb 2-4 3/29/2004, 1:44:47 PM