Philips FW-D750 - Manual (Page 15)

15
English
Functional Overview
Controls on the system
1 ECO POWER
–
to switch the system on or to Eco Power
Standby mode.
2 STANDBY ON2
–
to switch the system on or to Standby mode.
3 DISPLAY SCREEN
–
to view the current status of the system.
4 DISC TRAYS
5 DISC CHANGE
–
to change disc(s).
6 DISC 1 / DISC 2 / DISC 3
–
to select a disc tray for playback.
7 OPEN•CLOSE
–
to open or close the disc tray.
8 INTERACTIVE VU METER
–
to show the VU (volume unit) meter in music or
volume mode depending on the display mode
selected.
9 SENSOR
–
point the remote control towards this sensor.
0 VOLUME
–
to increase or decrease the volume.
! Tape Deck Operation
AUTO REPLAY
– to select continuous playback in either AUTO
PLAY or ONCE mode only.
DUBBING
– to dub a tape.
REC
– to start recording on tape deck 2.
@ VOCAL
–
to fade out the original vocal from Karaoke or to
switch between mono or stereo mode during
audio disc playback.
# JOG CONTROL
–
to select the desired sound effect for the
selected sound feature.
$ KEY CONTROL
–
to change the tone level to suit your vocal range.
I .................to decrease the key tone level.
.................to restore the key tone level to
original setting.
i .................to increase the key tone level.
% ECHO
–
to adjust the echo level for karaoke after
inserting the microphone.
^ SOUND
–
to activate or deactivate the surround sound
effect.
& wOOx ON•OFF
–
to select enhanced or normal wOOx sound
effect.
wOOx LEVEL
– to select a desired wOOx level: WOOX 1,
WOOX 2 or WOOX 3.
* MIC/LEVEL
–
to connect microphone jack.
– to adjust the mixing level for karaoke or
microphone recording.
( 0
– to open the tape deck door.
) TAPE DECK 1
¡ TAPE DECK 2
™ SOURCE
–
to select the following:
DISC (DISC 1•2•3)
– to select disc tray 1, 2 or 3
TUNER (BAND)
– to select waveband: FM or MW.
TAPE (TAPE 1-2)
– to select tape deck 1 or 2.
AUX/TV
– to select a connected external source: TV/CDR
or AUX (auxiliary) mode.
£ Mode Selection
PLAY/PAUSE 38
for DISC .................... to start or interrupt playback.
for TAPE ..................... to start playback.
for PLUG&PLAY ... (on the system only) to initiate
plug & play mode.
SEARCH•TUNING 1 ¡
(ALBUM – / +)
for DISC .................... to search backward/forward.
for TAPE ..................... to rewind or fast forward.
for TUNER ............... to tune to a lower or higher
radio frequency.
for CLOCK .............. (in standby mode)to set the
minute and hour.
DEMO STOP/CLEAR 7
for DISC .................... to stop playback or to clear a
programme.
for DEMO ................ (in Standby or ECO power
mode) to activate/deactivate
demonstration.
for PLUG&PLAY ... (on the system only) to exit
plug&play mode.