Philips FW-D750 - Manual (Page 40)

40
English
To activate the timer (for the same preset
time and source)
1 Press and hold TIMER for more than 3
seconds.
2 Press TIMER again to store the start time.
➜ The last set timer information will be shown
for a few seconds and TIMER
will appear on
the display.
Notes:
– If the source is disc mode, playback will begin
with the first track of the last selected disc or other
trays if the disc is empty. If all disc trays are empty,
the system will automatically switch to Tuner mode.
– During timer setting, if no button is pressed
within 30 seconds, the system will exit timer setting
mode automatically.
– When the system is powered on, if the
memorized volume level is less than 20, the system
will automatically adjust to 20 increasingly. If the
memorized volume level is more than 20, the
system will adjust to the memorized level within 5
seconds.
– The timer will be cancelled when the power cord
is disconnected or if a power failure occurs.
Timer Operations
Setting the sleep timer
The sleep timer enables the system to switch to
Standby mode automatically at a preset time.
● Press SLEEP on the remote control repeatedly
and stop at the desired preset turn-off time.
➜ Following options are available (time in
minutes):
15 p30 p45 p60 p90 p120 pOFF
p
......
➜ “SLEEP” will show on the display panel
unless “OFF” is selected.
To check or change the setting
● Press SLEEP once to show the remaining time
before switching off. If you continue pressing the
SLEEP button, the next Sleep Timer option will
appear on the display.
To cancel the sleep timer
● Press SLEEP repeatedly until “OFF” is displayed,
or press the STANDBY ON button.