Pride Mobility scooter - Manual (Page 31)

Victory/Rev L/Mar03 www.pridemobility.com 31
I X . D I S A S S E M B L Y A N D A S S E M B L Y
Frame Separation
1. Push back on the seat post to pivot the scooter’s rear
section backwards until the rear section is standing ver-
tically on its rear bumper. See figure 20.
2. Lift the front section up until the lower pegs are no
longer in the slots. See figure 21.
3. Carefully lift the front section vertically away from the
rear section.
ASSEMBLY
1. Position the front and rear sections of your scooter as shown
in figure 22.
2. Align the lower slots of the front section with the cor-
responding pegs on the front of the rear section. See
figure 21.
3. Holding the seat post, slowly pivot the rear section
forward until the curved locking brackets are fully con-
nected onto the top rear pegs. See figure 20.
4. Raise the tiller.
5. Secure the toggle latch. See figure 18.
n Lower the toggle latch buckle.
n Push back on the toggle latch so it locks into place.
6. Connect the front-to-rear cable and both battery har-
nesses.
7. Replace the rear shroud.
8. Replace the seat.
Figure 22. Frame Halves
SLOTS
PEGS
Figure 20. Frame Positioning
Figure 21. Frame Lockup
CAUTION! Position the front-to-rear
cable so it won’t become pinched
between the frame halves when
pivoting the rear section forward.