Philips CF-30FTSAZAM - Manual (Page 44)

7-23
■ Assembly of LAN, Modem and MDC
■ Assembly of Main PCB
Safety Working
MDC
5 1
15 1
Tighten of
Screw
Tighten of
Screw
Tighten of
Screw
Tighten of
Screw
LAN Cable
is installed.
Modem Cable
is installed.
Modem LAN Case
is installed.
Cable Coil
Attach the DMD Cable Sheet
Order of fixing
Screw Screw
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Pass the Cable to the back
from the hole of the A side.
(Remove 2 places)
Match to the edge of the Connector. 1
Process the cable and cover
with MDM Cable Sheet
Separate from the coil.
Attach space
CAUTION S1:Insulation S2:Pinching Cables S3:Sharp Edge
S4:Part No. Check S5:Others
S2
Safety Working
Connect the LAN cable.
CAUTION
S1:Insulation S2:Pinching Cables S3:Sharp Edge
S4:Part No. Check S5:Others
Put the cable ina a U-shape into the
intermediate chassis aperture next to the connector.
Do not pinch the cable out of the USB PCB.
Safety Working
Attach the PET Sheet
0 1
0 1
1 2
Cable SATA Signal Insertion
Sheet wrap
Safety Working
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Insert the connector wrapped with the
sheet into the connector on the board.
Bend the cable avoiding the connector.
S3
S3
S2