Before requesting service (problems and, Solutions), Before requesting service (problems and solutions) – Philips PV-GS55 User Manual

Page 73

Advertising
background image

Others

-73-

≥Be sure to keep the Lens Hood attached to the

Palmcorder so as to shut out unnecessary light.

Before Requesting Service
(Problems and Solutions)

Power
1: The Palmcorder power cannot be turned on.
• Is the power source connected correctly? (

-16-

)

2: The Palmcorder power is turned off

automatically.

≥When the Recording Pause Mode continues for

more than 5 minutes, the power is turned off
automatically for tape protection and power
conservation. (If the AC Adaptor is used, the
power is turned off only when the tape is
inserted in Tape Recording Mode.) When the
tape is inserted in Tape Recording Mode and if
the Recording Pause Mode continues for more
than 5 minutes the power is turned off
automatically. To resume recording from this
condition, turn off, then turn on the power again.
(

-25-

,

-26-

,

-27-

)

3: The Palmcorder power does not stay on

long enough.

• Is the Battery low? Charge the Battery or

attach a fully charged Battery. (

-16-

)

• Has condensation occurred? Wait until the

Condensation Indication disappears. (

-70-

)

Battery
1: Battery runs down quickly.
• Is the Battery fully charged? Charge it with the

AC Adaptor. (

-16-

)

• Are you using the Battery in an extremely cold

place? In cold places, the operating time of the
Battery becomes shorter. (

-71-

)

• Has the Battery worn out? If the operating time

is still too short even after the Battery is fully
charged, the Battery has worn out.

2: The Battery cannot be charged.
• If the DC Cable is connected to the AC

Adaptor, charging cannot be performed.
Disconnect the DC Cable.

Normal Recording
1: Recording does not start although power is

supplied to the Palmcorder and the
Cassette is correctly inserted.

• Is the accidental erasure prevention slider on

the Cassette open? If it is open (set to [SAVE]),
recording cannot be performed. (

-18-

)

• Is the tape wound to the end? Insert a new

Cassette. (

-18-

)

• Is the Palmcorder power turned on? (

-25-

)

• Has condensation occurred? Wait until the

Condensation Indication disappears. (

-70-

)

Other Recording
1: Auto Focus Function does not work.
• Is Manual Focus Mode selected? If Auto Focus

Mode is selected, focus is automatically
adjusted. (

-34-

)

• There are some recording subjects and

recording surroundings for which the Auto
Focus Function does not operate correctly. In
this case, use the Manual Focus Mode to
adjust the focus. (

-74-

)

Editing
1: Audio dubbing cannot be performed.
• Is the accidental erasure prevention slider on

the Cassette open? If it is open (set to [SAVE]),
recording cannot be performed. (

-18-

)

• Are you attempting to edit a tape portion that

was recorded in LP Mode? LP Mode does not
allow audio dubbing to operate. (

-24-

)

Indications
1: The Time Code becomes inaccurate.
0 The Time Code Indication counter may not be

constant in the reverse direction in Slow Motion
Playback Mode, but this is not a malfunction.

2: The Remaining Tape Time Indication does

not match the actual remaining tape time.

• If scenes of less than 15 seconds are

continuously recorded, the remaining tape time
cannot be displayed correctly.

• In some cases, the Remaining Tape Time

Indication may show remaining tape time that
is 2 to 3 minutes shorter than the actual
remaining tape time.

Playback (Pictures)
1: Pictures cannot be played back even when

the [

1] Button is pressed.

0 Is the Mode Dial set to Playback Mode? If not,

the playback function cannot be used. (

-37-

)

2: Mosaic-pattern noise appears on images

during Cue, Review or Slow Motion
Playback.

• This phenomenon is characteristic of digital

video systems. It is not a malfunction.

3: Although the Palmcorder is correctly

connected to a TV, playback images cannot
be seen.

• Have you selected “Video Input” on the TV?

Please read the operating instructions of your
TV and select the channel that matches the
input sockets used for the connection.

• Depending on your TV, nothing may be shown

even if you correctly connect the Palmcorder
with your TV. In this case, set [AV JACK] on
the [AV IN/OUT] or [INITIAL] Sub-Menu to
[OUT].

PV-GS55PP_Eng.book 73 ページ 2004年2月10日 火曜日 午前11時51分

Advertising