Pioneer PDP-501MX - Manual (Page 94)

94
Integrator Mode
Screen 1
]
MENU – –
WHITE BALANCE
SCREEN
3ADDITIONAL SET UP
TOTAL INITIALIZE
PICTURE
Screen 2
]
ADDITIONAL SET UP – –
COLOUR MODE : 1
BAUD RATE :
4800BPS
HOUR METER : 00123
MIRROR MODE : OFF
EXIT
3STD-RGB : OFF
SIDE MASK ADJ.
1 Enter the Integrator mode (refer to “5.4.1 About the
Integrator Mode”).
The ID number of the set of adjustment items will be
indicated in the upper right corner of the screen, where
“– –”is displayed in the illustration.
Select ADDITIONAL SET UP.
2 Move the cursor to STD-RGB and change the setting with
the SET button.
Pressing the SET button toggles STD-RGB between ON and
OFF.
STD-RGB applies to INPUTs 3 and 4 simultaneously.
Changing the setting in step 2 switches both inputs
immediately to ON or OFF.
Select EXIT in screen 2 to return to screen 1.
7) Setting STD-RGB
The STD-RGB needs to be set to ON when letting the display show standard rate (15.6 kHz x 50 Hz or 15.7 kHz x 60
Hz) RGB signals coming from external RGB processors or similar units.
(With STD-RGB set to OFF, no standard rate RGB signals show up on the display screen.)
The primary image quality is not, however, ensured when the STD-RGB is set to ON because this setting simplifies
the video signal processing.
Note: The mirror mode (see 5-3-4, paragraph 6) is not available when a RGB signal is replayed at standard speeds
(15.7 kHz x 60 Hz or 15.6 kHz x 50 Hz); in this case no images are displayed on the screen in Mirror mode.