Philips LX8320 - Manual (Page 36)

36
3139 115 23251
English IMPORTANT!
Make sure the FM and MW
antennas are connected.
Tuning to radio stations
1
Press SOURCE control to select
“
TUNER FM” or “TUNER MW”.
2
Press
34 briefly on the remote.
➜ " SEARCH" appears.
➜
The next radio station will tune
automatically.
3
Repeat step
2
if necessary until you find
the desired radio station.
4
To tune a weak station, press
S / T
briefly and repeatedly until an optimal
reception is found.
●
If the FM station reception is weak, you
can switch the FM mode from stereo to
mono. Press SURR button will toggle
through:
DOLBY PL II FM ST (stereo)
™ DOLBY PL II FM MONO
™ STEREO FM MONO
™ STEREO FM ST
Presetting radio stations
You can store up to 20 FM and 10 MW
preset radio stations in the memory.
Helpful Hints:
– The system will exit presetting mode if no
button is pressed within 20 seconds.
– If no valid frequency is detected during
Plug and Play,"
CHECK ANTENNA" appears.
Using the Plug and Play
Plug and Play allows you to store all
available radio stations automatically.
1 2
AUTO INSTALL PRESS PLAY
1
For first time setup, press SOURCE
on front panel to select TUNER mode.
➜
"
AUTO INSTALL PRESS PLAY"
appears.
2
Press 2; on the top panel to start
installation.
➜
"
INSTALL TUNER" appears.
➜
Once complete, the last tuned radio
station will play.
➜
FM followed by MW bands will be
stored.
Tuner Operations
001-045-LX8320-69-Eng2 13/08/2004, 11:25 AM 36