Philips LX8320 - Manual (Page 37)

English
37
3139 115 23251
Automatic presetting
You can start the automatic presetting
from a selected preset number.
1
3
02
FM / MW
AUTO
2
1
Press SOURCE control to select
“
TUNER FM” or “TUNER MW”.
2
Press 1 2 or use the numeric keypad
(0-9) to select a preset number to begin.
3
Press and hold PROGRAM until "
AUTO"
appears.
➜
If a radio station is stored in one of the
earlier presets, the same radio station will
not store under another preset number.
➜
If no preset number is selected,
automatic preset will begin from preset
(1) and all your former presets will be
overridden.
Manual presetting
You can choose to store only your
favourite radio stations.
1
Tune to your desired radio station (see
“Tuning to radio stations”).
2
Press PROGRAM.
3
Press 1 2 to select a preset number.
4
Press PROGRAM again to store.
Selecting a preset radio
station
●
Press 1 2 or use the numeric keypad
(0-9) to select a preset number.
➜
The waveband, preset number followed
by radio frequency will appear.
Deleting a preset radio station
● Press and hold 9 until “ MWXX
DELETED” or “FMXX DELETED”
appears.
➜
The current preset radio station will
be deleted.
Changing tuning grid (not available
for all versions)
In some countries, the frequency step
between adjacent channels in the MW
band is 9 kHz (10 kHz in some areas).
The preset frequency step in the factory
is 9 kHz.
IMPORTANT!
Changing the tuning grid will erase
all previously stored preset radio
stations.
1
Press SOURCE repeatedly to select
“
TUNER FM” or “TUNER MW”.
2
Disconnect the power cord from the
power supply.
3
While holding down SOURCE and
S
buttons on the front panel, connect the
power cord to the power supply again.
➜
The display will show "
GRID 9" or
"
GRID 10".
Helpful Hints:
– GRID 9 and GRID 10 indicate that the
tuning grid is in step of 9 kHz and 10 kHz
respectively.
– The FM tuning grid also will be changed
from 50 kHz to 100 kHz or vice versa.
Tuner Operations
DVD system’s
display panel
001-045-LX8320-69-Eng2 13/08/2004, 11:25 AM 37