Pioneer S-EV500V - Manual (Page 12)

Connecting up 02
12
En
Connecting using the component
video output
If your TV has component video inputs, you can
use these instead of the standard or S-Video
output to connect this system to your TV. 1 This
should give you the best quality picture from
the three types of video output available.
• Use a component video cable to connect
the COMPONENT VIDEO OUT to a set of
component inputs on your TV.
About progressive scan video
Compared to interlace video, progressive scan
video effectively doubles the scanning rate of
the picture, resulting in a very stable, flicker-
free image. Progressive scan video is available
only from the component video output.
Important
• If you connect a TV that is not compatible
with a progressive scan signal and switch
the system to progressive, you will not be
able to see any picture at all. In this case,
press
STANDBY/ON to put the system
in standby, then press and hold the front
panel (stop) button for about 7 seconds
until the display shows MEM.CLR? . Press
the front panel or button so that
the display shows INTERL? . Press the front
panel button to set to interlace and
switch the system back on.
Compatibility of this player with
progressive-scan and high-definition TVs.
This player is compatible with progressive
video Macro Vision System Copy Guard. 2
This system is compatible with the following
Pioneer displays and monitors: PDP-505HDG,
PDP-435HDG, PDP-5040HD, PDP4340HD,
PDP-502MX, PDP-503HDG, PDP-504HDG,
PDP-433HDG, PDP-434HDG, SD-532HD5,
SD533HD5.
Connecting auxiliary components
This system has both stereo analog inputs and
outputs. Use these to connect external
components, such as a VCR, MD, CD-R or DAT
recorder.
• Connect the LINE IN jacks on the rear
panel to an auxiliary playback component.
These include components such as a VCR,
DAT, or your TV. Connect using RCA pin-plug
stereo cables.
• Connect the LINE OUT jacks on the rear
panel to a recording component.
These include components such as a cassette
deck, VCR, MD recorder, or another recorder
with analog inputs. Connect using RCA pin-
plug stereo cables.
Note
1 The component video output is switchable between interlaced and progressive formats. See Video Output settings on page 44.
COMPONENT VIDEO OUT
L
R
L
R
CUT
LINE
VIDEO
OUT
PR PB
Y
S VIDEO OUT
IN
COMPONENT
INPUT
2 Consumers should note that not all high-definition television sets are fully compatible with this product and may cause arti-
facts to be displayed in the picture. In case of 525 progressive scan picture problems, it is recommended that the user switch
the connection to the ‘standard definition’ output (Interlace). If there are questions regarding our TV set compatibility with this
model, please contact our customer service center.
EV-500-1000.book 12 ページ ２００５年４月５日 火曜日 午後１２時３１分