04 getting started, Setting the clock, Setting up the remote to control your tv – Pioneer S-EV500V User Manual
Page 19: Using the on-screen displays, Getting started, Getting started 04, Chapter 4
Getting started
04
19
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 4
Getting started
Setting the clock
Setting the clock allows you to use the timer.
1
1
Press
TIMER
(SHIFT+6).
2
If ‘CLK ADJ?’ isn’t in the display, select it
with
or
, then press
ENTER
.
3
Use
/
to set the hour. Press
ENTER
.
4
Use
/
to set the minute then press
ENTER
to confirm.
Setting up the remote to control
your TV
You can set up the supplied remote to control
your TV using the
TV CONTROL
buttons.
2
1
Switch on your TV.
2
Find the name of the manufacturer of
your TV in the Preset Code List on page 60.
Next to each manufacturer is one or more
three digit codes. These tell the remote what
kind of TV you have.
If the name of the manufacturer of your TV
does not appear in the table, you won’t be able
to set up this remote to control your TV.
3
Point the remote at your TV, hold down
the CLEAR button, then enter the three
digit code for your TV.
The remote transmits an on/off signal to the TV.
If you’ve entered the correct code, your TV
should switch off.
If your TV doesn’t turn off, repeat the procedure
using the next code in the list until your TV
switches off successfully. Once set, you can
then use the individual TV controls shown
below.
Using the on-screen displays
For ease of use, this system makes extensive
use of graphical on-screen displays (OSDs).
All the screens are navigated in basically the
same way, using the cursor buttons (
,
,
,
) to change the highlighted item and
pressing
ENTER
to select it.
3
Note
1 The default setting is 12-hour format. See
Optional system settings
on page 48 to change it.
2 • The default setting is for a Pioneer TV.
• Note that there are also cases where the codes listed for a manufacturer in the Preset Code List may not work for your TV.
SYSTEM SETUP
HOME
MENU
TOP MENU
DVD MENU
RETURN
SOUND
MODE
ENTER
TUNE +
ST +
ST –
TUNE –
3
4
5
6
7
8
9
0
ENTER
SHIFT
CHANNEL
VOLUME
INPUT
ST.MEMORY
TEST TONE
MONO
CH LEVEL
TIMER
TV CONTROL
Button
What it does
Switches your TV on or into
standby.
CHANNEL +/–
Changes the TV channel.
VOLUME
Adjusts the volume.
INPUT
Switches the TV’s input
between the built in TV tuner
and an external video source.
3 The screen saver will appear after five minutes of inactivity.
EV-500-1000.book 19 ページ ２００５年４月５日 火曜日 午後１２時３１分