ParaBody Leg Press 100101 - Manual (Page 5)

FIGURE 2
STEP 2:
• SECURELY assemble one 3/8” SPRING PIN (33) to the spring pin barrel on the SEAT FRAME (2) as shown in FIGURE 2.
• Insert two 2” SQ. ENDCAPS (13) into the ends of the SEAT FRAME (2) as shown in FIGURE 2.
2
13
33
14
• Attach four PARAGLIDE STRIPS (14) to the inside of the SEAT FRAME (2) using the following steps:
• Thoroughly clean all surfaces where the PARAGLIDE STRIPS (14) are to be attached.
• Remove the PARAGLIDE STRIPS (14) from the paper backing and firmly apply them to all shown surfaces.
5