Prima MAGICARD ID Card Printer - Manual (Page 5)

Ultra Electronics Card Systems
Magicard Prima Driver Manual 5
2. Installation
2.1 PRINTER INSTALLATION
Please note:
If your printer has an USB interface please follow the corresponding instructions
which will be included in the USB Kit.
2.2 PREPARATION OF THE P.C.
1. Follow the installation instructions of the Prima Printer instruction manual
2.
Turn off the PC and the printers. Remove the power cable from all hardware
and the connection cables between PC and printer
3.
Install the SCSI card in your PC as described by the manufacturers’ manual
4.
After the card is installed, turn on the PC
5.
After rebooting the PC, Windows should detect a new hardware device.
Follow now the installation wizard or install the needed driver to your machine
manually. After the installation is finished, reboot the machine.
6.
Run the ASPI check program (ASPICHK.EXE) on your machine to make
sure, that the ASPI layer is up to date. If this check fails, run the ASPI32.EXE
program for updating the ASPI layer. Reboot your PC again.
7.
Inside the Hardware Manager check the existing SCSI Card, that the card has
been installed properly without errors and conflicts in your system.
8.
Turn off your machine.