Changing the input signal, Press the input button – Panasonic PT-L759VU User Manual
Page 17
17
Press the INPUT button
(LCD Projector)
(Remote Control
Unit)
The input source for picture signals and the corresponding audio signals can
be changed by pressing the INPUT buttons on the Projector operating panel
or on the remote control.
The signal from the source which is connected to the RGB1/YP
B
P
R
connector is projected.
This terminal accepts input of RGB input signals from a personal computer
and DTV Format signals (RGB, YP
B
P
R
) from a DVD or a digital broadcast.
No monitor or Projector can automatically decide whether a Component
signal is the RGB-type or the YP
B
P
R
-type. So, you will have to select either
RGB or YP
B
P
R
manually.
The signal from the source which is connected to the VIDEO IN connector is
projected.
• To turn off the input signal on-screen display, please see “Turning off the input signal display” on page
• There is only one audio system circuit provided for the VIDEO AUDIO IN terminals for S-VIDEO and VIDEO signals.
Because of this, if using both S-VIDEO signals and VIDEO signals, it will be necessary to change over the connectors.
• There is only one audio system circuit provided for the AUDIO IN terminals for RGB1/YP
B
P
R
, RGB2,
DVI-D [PT-L759XU only] signals. Because of this, if using both RGB1/YP
B
P
R
,RGB2
signals and DVI-D signals, it will
be necessary to change over the connectors.
• The LCD Projector is shipped from the factory with the S-VIDEO/VIDEO signal selection function set to “AUTO.” If the
correct picture is not projected when VIDEO signal is input and it is necessary to change the input to match the input
signal, refer to “S-VIDEO/VIDEO Signal Format Selection” on page
to change the setting if you change the signal input to the RGB1/YP
B
P
R
connector.
• When RGB signal is input, please input the registered signals found on page
to change the setting if you change the signal select to the RGB2 IN/RGB1 OUT connector.
• When projecting via the DVI-D input, first connect the LCD Projector to your PC using the DVI cable, and then turn the
PC on.
The signal from the source which is connected to the RGB 2 IN/ RGB 1 OUT
terminal is projected.
This terminal accepts an RGB signal from a PC in addition to a DTV format
signal (RGB) from a digital broadcast, DVD, etc. And, by setting the terminal
to OUT, the signal input to the RGB1/YP
B
P
R
connector can be output. At that
time, the projected screen will go to blue back. (See page
O
E
D
I
V
O
E
D
I
V
-
S
2
B
G
R
T
U
O
1
B
G
R
2
B
G
R
D
-
I
V
D
1
B
G
R
P
Y
R
P
B
The signal from the source which is connected to the S-VIDEO IN connector
is projected.
Changing the input signal
or
Note
The signal input to the DVI-D (Digital Visual Interface)input terminal is
projected. The video signal from the PC is input to the LCD Projector as a
digital signal, you can enjoy superior picture quality. [PT-L759XU only]
[PT-L759XU
only]