Panasonic SC-HT830V - Manual (Page 8)

8
RQT7921
75 ≠ coaxial cable
This cable carries broadcast signals to the television whether the unit
is on or off so you do not need to connect the antenna directly to the
television.
But the picture and sound signal from this unit does not go
through the 75
≠ coaxial cable to the TV. Make sure you connect
one of the following terminals on this unit to the TV; the VIDEO
OUT terminal, the S-VIDEO OUT terminal or the COMPONENT
VIDEO OUT terminal. If the TV has none of these terminals,
consult your local dealer.
To enjoy cable and satellite television
Connection
l 44
Subscribe to a cable or satellite company.
∫ Connecting a television with COMPONENT VIDEO IN terminals
COMPONENT VIDEO OUT terminals
These terminals can be used for either interlace or progressive output
and provide a purer picture than the S-VIDEO OUT terminal.
Connection using these terminals outputs the color difference signals
(P
B /C B , P R /C R ) and luminance signal (Y) separately in order to achieve
high fidelity in reproducing colors.
≥The description of the component video input terminals depends on
the television or monitor (e.g. Y/P B /P R , Y/B-Y/R-Y, Y/C B /C R ). Connect
to terminals of the same color.
≥After making this connection, change the black level for a better
picture ( l 27, “Video”—“Black Level Control”).
To enjoy progressive video
≥Connect to the component video input terminals on a 480p
compatible television. (Video will not be displayed correctly if
connected to an incompatible television.)
≥All televisions manufactured by Panasonic and that have 480p input
connectors are compatible. Consult the manufacturer if you have
another brand of television.
∫ Connecting a television with an S-VIDEO IN terminal
S-VIDEO OUT terminal
The S-video terminal achieves a more vivid picture than the VIDEO
OUT terminal by separating the chrominance (C) and luminance (Y)
signals. (Actual results depend on the television.) [Note]
Connect to a different terminal group than that you used for the video
cable (e.g., “VIDEO 2”).
Picture from this unit’s VHS will not appear when you use the same
group input terminal connections because the S-video terminal input
takes precedence.
If irregular coloring occurs on your television
The supplied speakers are designed to be used close to a
television, but the picture may be affected with some televisions
and setup combinations.
If this occurs, turn the television off for about
30 minutes.
The television’s demagnetizing function should correct the
problem. If it persists, move the speakers further away from the
television.
For better video from DVD
The following connections are for video from the DVD section only. Make sure you have connected the VIDEO OUT terminal with the
television to view video from the VHS section.
You may need to change the video-input mode on the television to view video from the VHS and DVD sections. Read your television’s
operating instructions for details.
RF IN
RF OUT
LOOP
EXT
75
AM
ANT
FM
ANT
LOOP
ANT
GND
A
DIGITAL
TRANSMITTER
DVD/VHS EXT DVD
COMPONENT VIDEO OUT
Y
PB/
CB
P R /
C R
S-VIDEO OUT IN OUT
TO SB-WA830
COMPONENT
VIDEO IN
Y
P B
P R
Component video cables
(not included)
Television
(not included)
To VHF/UHF IN
Main unit
75 ≠ coaxial cable (included)
Video cable (included)
To VIDEO IN
Antenna cable
(not included)
RF IN
RF OUT
LOOP
EXT
75
AM
ANT
FM
ANT
LOOP
ANT
GND
A
DIGITAL TRANSMITTER
DVD/VHS EXT DVD
COMPONENT VIDEO OUT
Y
PB/
CB
P R /
C R
S-VIDEO OUT IN OUT
TO SB-WA830
IN
S-VIDEO
S-video cable
(not included)
Television
(not included)
75 ≠ coaxial cable (included)
Main unit To VIDEO IN
Video cable (included)
To VHF/UHF IN
Antenna cable
(not included)
RQT7921-P_ENG.book 8 ページ ２００５年２月４日 金曜日 午後４時５８分