Pride Mobility 1103 Ultra - Manual (Page 27)

Jazzy 1103 Ultra www.pridemobility.com 27
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback,
you can adjust it to four (4) different angles: 90°, 102°,
105°, or 107°.
To adjust the seatback angle:
1. Remove the adjusting screws from each seat hinge. See
figure 16.
2. Set the seatback at the desired angle.
3. Reinstall the adjusting screws to each seat hinge
and tighten.
Armrest Width Adjustment
You can change each armrest’s width independently of
the other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 16.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to
the floor. See figure 16.
2. Loosen the jam nut.
3. Turn the adjusting screw to raise the front of the arm-
rest or to lower the front of the armrest.
4. Tighten the jam nut to lock the adjusting screw
into place.
Armrest Height Adjustment
To change the armrest height:
1. Loosen the two setscrews located on the armrest receiver.
2. Raise or lower the armrest to the desired height.
3. Tighten the setscrews to secure the armrest.
V . C O M F O R T A D J U S T M E N T S
Figure 16. Seatback/Armrest Adjustment
ARMREST KNOB
JAM NUT
SEATBACK ANGLE
ADJUSTING SCREW
ARMREST HEIGHT
ADJUSTING
SETSCREWS
ARMREST ANGLE
ADJUSTING SCREW