Pride Mobility 1103 Ultra - Manual (Page 28)

28 www.pridemobility.com Jazzy 1103 Ultra
V . C O M F O R T A D J U S T M E N T S
Controller Position
You can move the controller in toward or out away from
the armrest, or change the position of the controller for ei-
ther left-hand or right-hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See
figure 17.
3. Slide the controller into or out of the armrest to the
desired position.
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the
rear shroud.
3. Unplug the controller connectors from the power pod.
4. Cut the wire tie(s) securing the controller cable to the
armrest.
5. Flip up the armrest and loosen the setscrew. See
figure 17.
6. Slide the controller out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the controller in the other armrest.
9. Tighten the setscrew to secure the controller.
10. Use a wire tie to secure the controller cable to the arm-
rest.
11. Route the controller connector to the back of the power
base.
12. Plug the controller connectors into the power pod. See
figure 7.
13. Reinstall the rear shroud and tighten the fasteners.
NOTE: If your power chair is equipped with a Syn-
ergy or TRU-Balance Seating System, refer to the
controller adjustment information contained in
separate manuals.
Figure 17. Underside of Armrest
SETSCREW
CONTROLLER BRACKET