NordicTrack VGR 850 - Manual (Page 7)

7
5
54
15
10
3
5. Route both Pulse Wires (15) into and up through the
Upright (3) as shown.
Attach the T-handle (10) to the Upright (3) with two
M6 x 16mm Button Head Bolts (54) and two M6
Nylon Locknuts (17).
17
4. Attach the two Wheel Brackets (38) to the Frame (1)
with the two M10 x 25mm Button Head Screws (42)
as shown.
Attach a Wheel (61) to each Wheel Bracket (38) with
an M10 x 45mm Button Head Bolt (59) and an M10
Nylon Locknut (29).
4
29
42
38
61
1
59
59
6. The Console (6) requires two “AA” batteries (not
included). Alkaline batteries are recommended. To
install batteries, turn the console over. Remove the
four M4 x 16mm Screws (34), and separate the
Console from the Console Base (14). Insert two bat-
teries into the battery clip as shown in the inset draw-
ing. Make sure that the negative ends of the bat-
teries (marked “—”) are touching the springs in
the battery clip.
Attach a Plastic Tie (9) to the battery clip as shown.
Attach the Console (6) to the Console Base (14) with
the four M4 x 16mm Screws (34), making sure that the
indicated wires are extending from the Console Base.
Be careful not to pinch the wires.
6
34
Wires
Battery
Clip
Batteries
6
14
9