Nikon HMSM4050 - Manual (Page 5)

5
Wall Mount Drilling Template
Mounting tools: Screwdriver, electric drill or awl. On hard surfaces, Motorola recommends that you pre-drill ½-inch
deep pilot holes with a drill bit slightly smaller than the bracket mounting screws before securing the bracket to the
surface. When mounting a sensor on soft surfaces like sheetrock, use an awl to punch holes in the material slightly
smaller than the plastic anchors included in the hardware mounting kit.
The illustration is drawn to a one-to-one scale, which means that it provides the exact dimensions required to mount
the unit.
Drill Holes In
These Positions
1.76 in
Table Mount Your Wireless Motion Sensor
The sensor can be placed on any horizontal surface.
1
Locate the sensor on a horizontal surface.
2
Ensure that fresh batteries have been installed.
Make a
3
djustments to the sensor coverage angle by tilting and panning the unit with your hand.