Netcom NB9 - Manual (Page 10)

10 NB9/NB9W ADSL+ VoIP Router
YML790 Rev8
DEFAULT SETTINGS
The following are the default LAN (Local Area Network) and WAN (Wide Area Network).
LAN (Management)
• Static IP Address: 192.168.1.1;
• Subnet Mask: 255.255.255.0;
• Default Gateway: blank;
WAN (Internet)
• Empty: Once you have run through ‘ADSL Quick Setup’ you will have a saved WAN connection;
• Default connection type: PPPoE (most common for Australian ISPs);
• VPI / VCI: 8 / 35;
Modem Access
• Username: admin
• Password: admin
Restore Factory Default Setting
Restore Factory Defaults will reset the NB9/NB9W to its factory default configuration.Occasionsmay present
themselves where you need to restore the factory defaults on your NB9/NB9W such as:
• You have lost your username and password and are unable to login to your NB9/NB9W’s web
configurationpage;
• You have purchased your NB9/NB9W from someone else and need to reconfigurethedevice to work with
your ISP;
• You are asked to perform a factory reset by NetComm Support staff
In order to restore your NB9/NB9W to its factory default settings, please follow these steps:
• Ensure that your NB9/NB9W is powered on (for at least 10 seconds);
• Use a paper clip or a pencil tip to depress the reset button for ten seconds and release. At this point, the
reset is in progress. Do not power off the unit at this point;
• When indicator lights return to steady green, reset is complete. The default settings are now restored.
The entire process takes about 45 seconds to complete;
• Once you have reset your NB9/NB9W to its default settings you will be able to access the device’s
configuration web interface using http://192.168.1.1 with username ‘admin’ and password ‘admin’;