Netcom NB9 - Manual (Page 44)

 NB9/NB9W ADSL+ VoIP Router
YML790 Rev8
ADVANCED
Advanced > WAN
Clicking on the ‘Advanced’ menu displays the following:
This screen provides a summary of the current WAN interfaces you have configured. If you have connected
the NB9/NB9W to ADSL through the ADSL Quick Setup interface, details of the connection will be
summarised here.
Setting up a WAN profile goes through a set of steps which establishes connection parameters covering
the following:
Field Means
VPI/VCI Always 8/35 in Australia
Con. ID Sequence number of connection (e.g. 1,2…)
Category ATM Service Category; leave as default
Service Name of connection: give this a name you will recognise (e.g. ISP name)
Interface Current WAN interface name
Protocol Bridge or Router Mode
IGMP Enable/Disable IGMP proxy
NAT Enable/Disable NAT (leave enabled unless advised otherwise by tech support)
Firewall Enable/Disable Firewall (leave enabled unless advised otherwise by tech support)
QoS Enable/Disable QoS; enable if VoIP services are being used.
State Enable/Disable this WAN connection
Once settings are entered, click Save. Connection status can be checked under Status>Diagnostics.
Choosing a WAN Profile
In the event that you wish to set up several connection profiles on your NB9/NB9W for use in different
locations OR with different ADSL services
• click ‘Add’ to add the next connection profile
• Repeat set up steps above
You are able to cycle through connection profiles in the Status>Diagnostics window; if more than one WAN
profile exists, a button will displayed for Next Connection in the sequence.