NordicTrack ViewPoint NTL11806.1 - Manual (Page 24)

24
HOW TO OPERATE THE PERSONAL TELEVISION
IMPORTANT: Before operating the television, you
must connect a 75 ohm CATV cable to the 75 ohm
terminal on the treadmill; a VCR or DVD player to
the audio/video input jack; or a personal
audio/video player to the audio/video jack below
the television on the console. See page 13 for in-
structions.
Follow the steps below to operate the television.
Insert the key into the console.
See HOW TO TURN ON THE POWER on page
16.
Press the Power button to turn on the
television, and press the AV button to select a
television source.
Press the Power button repeatedly until the word
TUNER appears on the screen. Next, select a
television source by pressing the AV button re-
peatedly. If you have connected a 75 ohm CATV
cable or a VCR to the 75 ohm terminal on the
treadmill, press the AV button until the word
TUNER appears on the screen. If you have
plugged a DVD player or a VCR into the three
audio/video RCA jacks, press the AV button until
the words INPUT 1 appear. If you have connected
a personal audio/video player to the audio/video
plug below the television on the console, press
the AV button until the word MP3 appears. Note:
To turn off the television, press the Power button
until the word CONSOLE appears.
Press the Channel buttons to select the
desired channel.
Note: Complete this step only if you are using
analog cable. Otherwise, change channels
through an external source such as your cable
box or your VCR.
When the television is turned on, the screen will
show the last cable channel that was selected. To
select a different channel, press the Channel
(CH.) buttons. The selected cable channel num-
ber will appear on the screen for a few seconds.
Note: The television is equipped with a channel
memorizing function that allows you to go directly
from the current channel to the next channel
saved in memory. Before channels can be se-
lected in this way, they must be saved in the tele-
vision’s memory. See HOW TO USE THE INFOR-
MATION MODE on page 25.
Press the Volume buttons to adjust the volume.
When either Volume (VOL.) button is pressed, the
volume level indicator will appear on the screen
for a few seconds.
To use earphones or headphones (not included),
plug them into the headphone jack below the key
on the console.
HOW TO USE THE STEREO SOUND SYSTEM
To play music or audio books through the console’s
stereo speakers, you must connect your MP3 player,
CD player, or personal audio/video player to the con-
sole. Locate the audio/video plug below the television
on the console, and plug it into a jack on your MP3
player, CD player, or personal audio/video player.
Make sure that the audio/video cable is fully
plugged in.
Next, press the Play button on your MP3 player, CD
player, or personal audio/video player. Then, adjust
the volume on your MP3 player, CD player, or per-
sonal audio/video player. You can also adjust the vol-
ume on the console by pressing the Volume increase
and decrease buttons.
If you are using a personal CD player or a DVD player
and the CD or DVD skips, set the CD player or DVD
player on the floor or another flat surface instead of on
the console.
4
3
2
1