Network Technologies RACKMUX-UW15-4USB - Manual (Page 2)

2
Loosen screws on back
of XTENDEX
Place bracket on XTENDEX over screws
and slide into keyhole slot. Tighten
screws on back of XTENDEX
3. Loosen the two screws on the back of the XTENDEX and apply the small
mounting bracket supplied with your kit. Slide the bracket so that the screws
on the XTENDEX are captured in the slots in the bracket. Tighten the screws.
Note: Some models of NTI XTENDEX instead have extra holes on the back
for mounting this bracket and require two additional screws to be applied.
Two extra #4-40 x 3/16” screws have been supplied with this kit for this
purpose.
4. Determine the desired mounting position for the XTENDEX on the monitor such that the cables will best approach the XTENDEX for
easy cable routing.
5. Loosely apply the two screws provided to the standoffs on the VESA mounting bracket that will be used to hold the XTENDEX in the
desired position (see image below).
6. Apply the XTENDEX to the two screws through the openings in the keyhole slots, slide the XTENDEX to capture the small mounting
bracket under the screw heads, and tighten the screws.
7. Hardware installation is complete. (See image on page 3.) Attach cables.
Secure XTENDEX to the VESA mounting
bracket using 2 screws supplied.
(Two sets of standoffs are provided for
your choice of mounting position. )
XTENDEX
XT
EN
D
EX
-OR-