NordicTrack TREADMILL NTL07707.1 - Manual (Page 9)

9
7. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly. Hold the Right Handrail (95) near the con-
sole assembly. Next, insert the console wire into
the large hole in the Right Handrail and out of
the top as shown. If necessary, use needlenose
pliers to pull the console wire out.
Attach the Right Handrail (95) and the Left
Handrail (not shown) with four #8 x 3/4" Screws
(1) (only two are shown).
Make sure that no
wires are pinched. Start all four Screws be-
fore tightening any of them; do not over-
tighten the Screws.
1 95
1
Console
Wire
Hole
7
8. Tighten a 1/4" x 1 1/4" Bolt (5) with a 1/4" Star
Washer (33) into the bracket and the Handrail
Crossbar (94) on each side of the console as-
sembly (only one side is shown).
Remove the wire tie from the console wire.
5
94
Console
Assembly
Wire
Tie
8
9. Remove the long tie from the Upright Wire (38).
Have a second person hold the console assem-
bly near the Right Upright (78) and the Left
Upright (not shown). Connect the Upright Wire
(38) to the console wire.
See the inset drawing.
The connectors should slide together easily
and snap into place. If they do not, turn one
connector and try again.
IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Attach the console assembly to the Right Upright
(78) and the Left Upright (not shown) with four
5/16" x 3 1/4" Bolts (7) and four 5/16" Star
Washers (10) (only two are shown).
Be careful
not to pinch the wires.
See steps 4 and 6. Tighten the four 3/8" x 5"
Bolts (6).
Console
Assembly
Console
Wire
Long
Tie
38
78
7
10
9
38
Console
Assembly
Console
Wire
33