NISSAN 2009 Altima Sedan - Manual (Page 18)

FOLDING DOWN THE REAR SEATS
FROM INSIDE THE VEHICLE
Ⅲ The rear seats can be locked using the mechanical key to
prevent unauthorized access.
Ⅲ Open the access cover and press the release button
to
fold down the center/passenger’s side rear seat.
Ⅲ Reach through the opening and pull on the strap
located
behind the seat to fold down the driver’s side rear seat.
FROM THE TRUNK
Ⅲ Pull the strap
located behind the seat to fold down the
center/passenger’s side rear seat.
Ⅲ Pull on the strap
located behind the seat to fold down the
driver’s side rear seat.
HOMELINK
ா UNIVERSAL TRANSCEIVER (if so equipped)
SYSTEM OPERATING TIPS
Ⅲ Garage doors, electrical gates, entry doors, etc. will be activated during programming.
To avoid injury, make sure that people and objects are clear of all doors or gates during
programming. Your vehicle’s engine should be turned off while programming the
HomeLink
ா Transceiver.
Ⅲ To program your HomeLinkா Transceiver to operate a garage door, gate, or entry door
opener, home or office lighting, you need to be at the same location as the device.
NOTE: Garage door openers (manufactured after 1996) have “rolling code pro-
tection”. To program a garage door opener equipped with “rolling code protec-
tion”, you will need to use a ladder to get up to the garage door opener motor to
be able to access the “smart” or “learn” program button.
PROGRAMMING YOUR HOMELINK
ா UNIVERSAL TRANSCEIVER (Mirror,
Sun Visor or Overhead Console)
1. To begin, press and hold the two
outer HomeLink
ா buttons (to clear
the memory) until the indicator light
blinks slowly (after 20 seconds).
Release both buttons.
2. Position the end of the hand-held
transmitter 1-3 in (26-76 mm) away
from the HomeLink
ா surface.
16