NETGEAR ANT2409 - Manual (Page 8)

Installation Guide for the 9 dBi Omni-directional Antenna ANT2409
1-2 Getting Started with the ANT2409
• NETGEAR Indoor / Outdoor 9 dBi 2.4 – 2.5GHz Omni-Directional Antenna ANT2409
• 2-meter low loss antenna cable to connect the antenna to a lightning arrestor
• Lightning Arrestor
NOTE: a ground cable is not included but required for outdoor installation. The grounding
cable must be equivalent or better than: AWG 10, UL 1015, Stranded, 600 V, 105
o C, green or
green/yellow insulation, 2 clip of 5.5 mm inner diameter cramped at both ends, cable no longer
than 5 meters.
• Reverse N/SMA Adapter
• Antenna mounting assembly (tube, grommet, 2 brackets, screws, washers)
• L shape bracket for top & ceiling mounting
• Screws, bolts, washers, U-bolts and plastic anchors
• Installation Guide
• Warranty and Support Information card
If any of the parts are incorrect, missing, or damaged, contact your NETGEAR dealer. Keep the
carton, including the original packing materials, in case you need to return the product for repair.
Antenna cable for connecting the wireless device is sold separately. Please use a NETGEAR
model ACC-10314-01, 02, 03, 04, or 05 cable.
To obtain optimal results in extending wireless range with antenna installations, consult a qualified
professional installer for site survey and installation assistance.
In the U.S., the ANT2409 antenna should only be used with devices that have been FCC approved
for use with it. Please check the NETGEAR web site at
http://www.NETGEAR.com/go/antennas_fcc for an updated list of FCC approved devices.
For Europe, use of any antenna requires careful planning and extra consideration to comply with
EU emissions and health standards and regulations. Antenna installation must comply with the
maximum level authorized by each country. Please check the NETGEAR web site
at http://www.NETGEAR.com/go/antennas_eu for a list of restrictions and approved devices.