Navman SmartS TM - Manual (Page 63)

6
PiN Pocket PC 00 | User Manual
18. Continuous Continental
Navigation
You can seamlessly navigate between installed maps without the need for installing all maps en route.
This is achieved by using a Basemap. A Basemap is a map of a large area, such as West Europe or the
United States, containing main roads that connect cities and towns. You can select a road or POI on the
Basemap as your start point or destination.
Basemaps:
• contain roads and ferry connections of high national and international importance
• use less memory than would be necessary to install all equivalent detailed maps
• do not include smaller roads and have a reduced level of geographical detail.
You can add and remove Basemaps using the Basemap Installer.
Install Basemap
1. Connect the PDA to your computer.
• Connect your PDA to your computer via Microsoft® ActiveSync® .5 or higher.
• Close all open programs on your PDA.
2. Open SmartS Desktop if it is not already open: Start > Programs > Navman > SmartS
Desktop.
. On the Map menu, click Basemaps. The Basemap Installer window will open.
4. Select the Basemap to install.
5. Click the appropriate Add button to install the Basemap to the PDA, memory card or
memory card reader.
Activate Basemap
1. From the Main Menu, tap Setup, then the Maps tab. The Active Map Selection Settings
screen will open.
2. Select a memory location from the Location drop-down box to display a list of the maps
installed in each location.
. Select the check box of the Basemap you require.
4. Tap to accept the change and open the Map screen.